Adaptive Digital Technologies - Voice Application Software / VoIP Solution- Site Links

IPVoice – VoIP Test Software for iPhone, iPod Touch, and iPad Mobile Digital Devices Support

Adaptive Digital

Correctly loaded, iPVoice test app
should appear as below.

QUICK START GUIDE data sheet pdf

The IP Voice test software can be used as a piece of test equipment to facilitate the testing of VoIP phones and gateways.

IPVOICE WEBPAGE

 

SUPPORT FOR IPVOICE VoIP TEST APPLICATION

Adaptive Digital provides support throughout all project phases; customers have access to our technical team directly over the phone or via email.
       610-825-0182

NOTE: THE FOLLOWING TEST INSTRUCTIONS ARE ALSO AVAILABLE THE QUICK START GUIDE - DOWNLOADdata sheet pdf

SET-UP

You will need to follow these instructions only once as long as all testing is done on the same WiFi network.

  1. Make sure the IPVoice application is installed on the iPhone(s).

  2. Join the WiFi network

    • Go to Settings > WiFi.

    i. Follow steps as indicated in below illustration.

    If the phone is already connected to the desired network, touch that network and record the phone’s unique IP address, skip to step 3.  To connect to desired network, continue.

    • Choose the appropriate network. If the network is encrypted choose Other.
    • Enter the name and security password for that network. Then click join
    • Once you have joined, touch the network and record the IP address of the phone

  3. If using two iPhones*, repeat the steps for both phones. In the case of running the conference test, three (3) iPhones will be required. It is best to perform each step on all phones at the same time as you will need information from one phone to be entered on the other phone.

  4. Run the IPVoice test application (IPV)

  5. First time only: Change the IP address field to the match the IP address of the OTHER phone (the one that this phone will be communicating with.) The IP address will be stored for subsequent calls after the first call is turned on and subsequently turned off.

    6. In the case of conference testing*, one iPhone is used to engage the conference (phone A), input IP address of second (phone B) and third (phone C) iPhones. Destination phones: Input only the IP address of the conference initiating iPhone (A) in the “Dest IP Addr 1” field on both the “B” and “C” designated iPhones .

* See quick start guide for block diagrams.

RUNNING THE TEST

  1. Start the app on both phones

  2. By default, the test is set up to run an end-to-end voice test using the G.711 mu-law codec. If that is the test you wish to run, click Call Active to turn on the test.

  3. If you wish to use a different codec or run a different test, use the picker (which looks like a slot machine) to select the appropriate settings BEFORE setting the call to the active state.

  4. When the test is complete, click the Call Active to off. This will exit the application.

Note that SRTP is not implemented in the test iPVoice application.

TROUBLESHOOTERS GUIDE

Simple solutions to attempt before calling:

  • Check that the RTP port is set to 6334
  • Make sure the IP address is correct

Note: This application is not a typical mass-market consumer application. It is intended to be used by engineers who develop VoIP equipment or by engineering students.

 

iPhone, iPod Touch, and iPad are registered trademarks of Apple Inc.

IPVoice is a trademark of Adaptive Digital Technologies, Inc.